T-Rex 0.25.12 released

Published on: 2022-04-15

44735836?s=60&v=4

  • (ethash) Improve LHR unlock functionality (dual modes and autolykos2 LHR performance is unchanged)
    Expect about 78-79% in normal mode, and 75% in low power mode (see --lhr-low-power)
  • Change default value of --lhr-autotune-mode parameter to down (used to be full)

Bug fixes:

  • (Linux) Memory temperature is not displayed on some GDDR6X cards

NOTE:
Make sure you remove any --lhr-tune settings you may have in your existing configuration. The miner will calibrate the unlocker and the hashrate should go up to its normal level in about a minute after the miner displays calibration finished message.

Recommended drivers:
Linux - 470.xx+
Windows - 512.xx (although 472.xx works fine too)

A few tips if you experience frequent LHR locks:

  1. Make sure you don't have monitors connected to your LHR cards, or at least turn them off during miner start up to let it calibrate correctly. Avoid using RDP if it puts load on your LHR cards.
  2. Do not delay applying overclock - this will mess up calibration results and the miner will display unrealistically high LHR tune values.
  3. Try reducing memory overclock of the GPU that frequently trips LHR.

T-Rex as a GPU miner for Nvidia.

Go to the T-Rex 0.25.12 released download page